Motorola WS2000 - Wireless Switch - Network Management Device Cli Reference Manual page 213

Wireless switch
Hide thumbs Also See for WS2000 - Wireless Switch - Network Management Device:
Table of Contents

Advertisement

no-mu-mu <idx> <mode>
vop <idx> <mode>
tkip key <idx> <key>
tkip type <idx> <type>
tkip phrase <idx> <phrase>
tkip rotate-mode <idx> <mode> Enables or disabled the broadcast key rotation for WLAN <idx> (1–8).
tkip interval <idx> <interval>
ccmp key <idx> <key>
ccmp type <idx> phrase/
key
ccmp phrase <idx> <phrase>
ccmp rotate-mode <idx>
enable/disable
ccmp interval <idx> <interval> Sets the broadcast key rotation interval for WLAN <idx> (1–8) to
ccmp mixed-mode <idx>
enable/disable
ccmp preauth <idx> enable/
disable
ccmp opp-pmk <idx> enable/
disable
wep-mcm index <idx> <kidx> Selects the WEP/KeyGuard key (from one of the four potential values of
wep-mcm key <idx> <kidx>
<key>
vlan-id <idx> <vlan-id>
mu-inact <timeout>
wep_shared <mode>
handshake-timeout <idx>
<timeout>
Enables or disables the stoppage of MU-to-MU communication for WLAN
<idx> (1–8).
Enables or disables the voice priority mode for WLAN <idx> (1–8).
Sets the TKIP key to <key> (1–64 hex digits) for WLAN <idx> (1–8).
Sets the TKIP key type to phrase or key for WLAN <idx> (1–8).
Sets the TKIP ASCII pass phrase to <phrase>
<idx> (1–8).
Sets the broadcast key rotation interval to <interval> seconds (300–
604800) for WLAN <idx> (1–8).
Sets the CCMP key to <key>
Must be specified when type parameter is set to key.
Sets the CCMP key type to phrase or key for WLAN <idx> (1–8).
Sets the CCMP ASCII pass phrase for WLAN <idx> (1–8) to <phrase> (8–
63
characters). Must be specified when type parameter is set to phrase.
Enables or disables the broadcast key rotation for WLAN <idx> (1–8).
<interval> (300–604800) seconds.
Enables or disables mixed mode (allowing WPA-TKIP clients) for WLAN
<idx> (1–8).
Enables or disables pre-authentication (fast roaming) for WLAN <idx> (1–
8).
Enables or disables opportunistic PMK caching (fast roaming) for WLAN
<idx> (1–8).
Note: The WEP authentication mechanism saves up to four different keys (one for
each WLAN). It is not a requirement to set all keys, but you must associate a WLAN
with the appropriate key.
<kidx> (1–4) for WLAN <idx> (1–8).
Sets the WEP/KeyGuard key for key index <kidx> (1–4) for WLAN <idx>
(1–8) to <key> 1 to 26 (hex digits).
Sets the VLAN-ID mapping to WLAN <idx> (1–8) to VLAN <vlan-id> (1–
4094).
Sets the MU inactivity timeout value to <timeout> (1-60) minutes.
Enables or disables WEP shared mode.
Sets the 802.11i handshake timeout value to <timeout>
the WLAN <idx> (1–8). This feature is provided to prevent those MUs that
do not receive EAPOL messages from restarting the association
procedure. The default retry for these MUs is 2 seconds. This switch is
provided to control the retry for EAPOL messages to a value that is less
than 2 seconds.
Network CLI Commands Reference
(8–63
characters) for WLAN
(1–64
hex digits) for WLAN <idx> (1–8).
3-177
(100-2000
ms) for

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents