Set - Motorola WS2000 - Wireless Switch - Network Management Device Cli Reference Manual

3-104 WS2000 Wireless Switch System Reference Guide
3.19.2 Network LAN Bridge set Command

set

Network LAN Bridge commands
Sets the bridge configuration parameters.
Syntax
set [priority|hello|msgage|fwddelay|ageout|wireless-trunking]
Parameters
priority <LAN-idx> <priority>
hello <LAN-idx> <hello>
msgage <LAN-idx> <msgage>
fwddelay <LAN-idx> <fwddelay>
ageout <LAN-idx> <ageout>
wireless-trunking <LAN-idx> <mode> Sets the wireless trunking mode <mode> (enable/disable) for lan
Example
admin(network.lan.bridge)>set priority 1 5
admin(network.lan.bridge)>set wireless-trunking 1 enable
admin(network.lan.bridge)>show
** LAN1 Bridge Configuration **
Bridge Priority
Hello Time (seconds)
Message Age Time (seconds)
Forward Delay Time (seconds)
Entry Ageout Time (seconds)
Wireless Trunking
** LAN2 Bridge Configuration **
Bridge Priority
Hello Time (seconds)
Message Age Time (seconds)
Forward Delay Time (seconds)
Entry Ageout Time (seconds)
Wireless Trunking
[...]
Sets the bridge priority to <priority> (0-65535) for the lan <LAN-
idx> (1-6)
Sets the bridge's hello time to <hello> (1-10) seconds for the lan
<LAN-idx> (1-6)
Sets the bridge message age time to <msgage> (6-40) seconds for
lan <LAN-idx> (1-6)
Sets the bridge forward delay time to <fwddelay> (4-30) seconds
for lan <LAN-idx> (1-6)
Sets the bridge forward table entry ageout to <ageout> (4-3600)
seconds for lan <LAN-idx> (1-6).
<LAN-idx> (1-6)
: 5
: 2
: 20
: 15
: 60
: enable
: 32768
: 2
: 20
: 15
: 60
: disable