NETGEAR ProSafe GSM5212P Software Administration Manual page 500

a. Select Routing > IP > Advanced > IP Interface Configuration. A screen similar to
the following displays.
b. Scroll down and select the Port 1/0/13 check box. Now 1/0/13 appears in the Port
field at the top.
c. Enter the following information in the IP Interface Configuration.
• In the IP Address field, enter 192.168.2.2.
• In the Subnet Mask field, enter 255.255.255.0.
• In the Routing Mode field, select Enable.
d. Click Apply to save the settings.
3. Configure 1/0/20 as a routing port and assign an IP address to it.
a. Select Routing > IP > Advanced > IP Interface Configuration. A screen similar to
the following displays.
b. Scroll and select the Port 1/0/20 check box. Now 1/0/20 appears in the Interface field
at the top.
c. Enter the following information:
• In the IP Address field, enter 192.168.4.1.
• In the Subnet Mask field, enter 255.255.255.0.
• In the Routing Mode field, select Enable.
d. Click Apply to save the settings.
4. Enable IP multicast on the switch.
500 | Chapter 31. DVMRP
ProSafe Managed Switch