Rip For Ports 1/0/2 And 1/0/3 - NETGEAR ProSafe GSM5212P Software Administration Manual
Managed switch 9.0.2
Hide thumbs
Also See for ProSafe GSM5212P:
- Software setup manual (36 pages) ,
- Hardware installation manual (28 pages) ,
- Installation manual (2 pages)
Table of Contents
Advertisement
Web Interface: Enableg RIP on the Switch
1.
Select Routing > RIP > Basic > RIP Configuration. A screen similar to the following
displays.
2.
For RIP Admin Mode, select Enable radio button.
3.
Click Apply to save the setting.
RIP for Ports 1/0/2 and 1/0/3
The example is shown as CLI commands and as a Web interface procedure.
CLI: Enable RIP for Ports 1/0/2 and 1/0/3
This command sequence enables RIP for ports 1/0/2 and 1/0/3. Authentication defaults to
none, and no default route entry is created. The commands specify that both ports receive
both RIPv1 and RIPv2 frames, but send only RIPv2-formatted frames.
(Netgear Switch) #config
(Netgear Switch) (Config)#interface 1/0/2
(Netgear Switch) (Interface 1/0/2)#ip rip
(Netgear Switch) (Interface 1/0/2)#ip rip receive version both
(Netgear Switch) (Interface 1/0/2)#ip rip send version rip2
(Netgear Switch) (Interface 1/0/2)#exit
(Netgear Switch) (Config)#interface 1/0/3
(Netgear Switch) (Interface 1/0/3)#ip rip
(Netgear Switch) (Interface 1/0/3)#ip rip receive version both
(Netgear Switch) (Interface 1/0/3)#ip rip send version rip2
(Netgear Switch) (Interface 1/0/3)#exit
(Netgear Switch) (Config)#exit
58 |
Chapter 6. RIP
ProSafe Managed Switch
Advertisement
Table of Contents
