Outbound Telnet - NETGEAR ProSafe GSM5212P Software Administration Manual

a. Select Maintenance > File Management > Dual Image Configuration. A screen
similar to the following displays.
b. Under Dual Image Configuration, scroll down and select the Image 2 check box. The
image2 now appears in the Image name field at the top.
c. In the Active Image field, select TRUE.
d. Click Apply.

Outbound Telnet

In this section, the following examples are provided:
• CLI: show network
• CLI: transport output telnet
• Web Interface: Configure Telnet
• CLI: Configure the session-limit and session-timeout
• Web Interface: Configure the Session Timeout
Outbound Telnet:
• Establishes an outbound Telnet connection between a device and a remote host.
• A Telnet connection is initiated, each side of the connection is assumed to originate and
terminate at a network virtual terminal (NVT).
• Server and user hosts do not maintain information about the characteristics of each
other's terminals and terminal handling conventions.
• Must use a valid IP address.
304 | Chapter 17. Tools
on page 305
on page 306
on page 306
ProSafe Managed Switch
on page 307
on page 307