Stack Switches Using 10G Fiber - NETGEAR ProSafe GSM5212P Software Administration Manual

ProSafe Managed Switch
a. Select System > Stacking > Advanced > Stack Port Configuration. A screen
similar to the following displays.
b. Under Stack Port Configuration, scroll down and select the 1/0/51 check box.
c. In the Configured Stack Mode list, select Ethernet.
d. Click Apply to save the settings.
4. Reboot the switch.
a. Select Maintenance > Reset > Device Reboot. A screen similar to the following
displays.
b. In the Reboot Unit No. list, select 1 .
c. Click Apply.

Stack Switches Using 10G Fiber

This example shows how to stack two switches in different buildings at long distance using
10G fiber. First insert AX741 to I/O slot on Switch A, and insert AX741 to I/O slot on Switch B.
Then connect the two AX741 with fiber.
Switch A
Figure 37. Using 10G fiber to stack switches in different buildings
AX741
Switch B
Ax741
Chapter 19. Switch Stacks | 327