Configure Multiple Stp (802.1S) - NETGEAR ProSafe GSM5212P Software Administration Manual
Managed switch 9.0.2
Hide thumbs
Also See for ProSafe GSM5212P:
- Software setup manual (36 pages) ,
- Hardware installation manual (28 pages) ,
- Installation manual (2 pages)
Table of Contents
Advertisement
ProSafe Managed Switch
a. Select Switching > STP > CST Port Configuration. A screen similar to the following
displays.
b. Under CST Port Configuration, scroll down and select the Interface 1/0/3 check box.
Now 1/0/3 appears in the Interface field at the top.
c. In the Port Mode field, select Enable.
d. Click Apply.
Configure Multiple STP (802.1s)
The example is shown as CLI commands and as a Web interface procedure.
CLI: Configure Multiple STP (802.1s)
(Netgear switch) (Config)# spanning-tree
(Netgear switch) (Config)# spanning-tree forceversion 802.1s
(Netgear switch) (Config)# spanning-tree mst instance 1
Create a mst instance 1
(Netgear switch) (Config)# spanning-tree mst priority 1 4096
(Netgear switch) (Config)# spanning-tree mst vlan 1 2
(Netgear switch) (Config)# spanning-tree mst vlan 1 3
Associate the mst instance 1 with the VLAN 2 and 3
(Netgear switch) (Config)# spanning-tree mst instance 2
Create a mst instance 2
(Netgear switch) (Config)# spanning-tree mst priority 2 4096
(Netgear switch) (Config)# spanning-tree mst vlan 2 11
(Netgear switch) (Config)# spanning-tree mst vlan 2 12
Associate the mst instance 2 with the VLAN 11 and 12
(Netgear switch) (Interface 1/0/3)# spanning-tree mst 1 port-priority 128
(Netgear switch) (Interface 1/0/3)# spanning-tree mst 1 cost 0
Chapter 25. Spanning Tree Protocol
| 379
Advertisement
Table of Contents
