NETGEAR ProSafe GSM5212P Software Administration Manual page 249

Managed switch 9.0.2

Hide thumbs Also See for ProSafe GSM5212P:

Table of Contents

ProSafe Managed Switch

a. Select Routing > VLAN > VLAN Routing Wizard. A screen similar to the following

b. Enter the following information:

In the Vlan ID field, enter 202.

In the IP Address field, enter 10.100.5.34.

In the Network Mask field, enter 255.255.255.0.

c. Click Unit 1. The ports display:

d. Click the gray box under port 48 twice until U displays. The U specifies that the

egress packet is untagged for the port.

e. Click Apply to save the VLAN that includes port 48.

Enable IP routing:

a. Select Routing > IP > Basic > IP Configuration. A screen similar to the following

b. Under IP Configuration, make the following selections:

For Routing Mode, select the Enable radio button.

For IP Forwarding Mode, select the Enable radio button.

c. Click Apply to enable IP routing.

Configure default route for VLAN 202:

Chapter 15. Security Management