NETGEAR ProSafe GSM5212P Software Administration Manual page 369

ProSafe Managed Switch
• Click the gray box under port 48 once until T displays. The T specifies that the
egress packet is tagged for the port.
d. Click Apply to save the settings.
3. Change the port VLAN ID (PVID) of port 24 to 200:
a. Select Switching > VLAN > Advanced > Port PVID Configuration. A screen similar
to the following displays.
b. Scroll down and select the Interface 1/0/24 check box. Now 1/0/24 appears in the
Interface field at the top.
c. In the PVID (1 to 4093) field, enter 200.
d. Click Apply to save the settings.
4. Configure port 48 as the provider service port:
a. Select Switching > VLAN > Advanced > Port DVLAN Configuration. A screen
similar to the following displays.
Chapter 24. Double VLANs and Private VLAN Groups | 369