NETGEAR ProSafe GSM5212P Software Administration Manual page 458

Managed switch 9.0.2

Hide thumbs Also See for ProSafe GSM5212P:

Table of Contents

a. Select System > Services > DHCP L2 Relay > DHCP L2 Relay Configuration. A

screen similar to the following displays.

b. For Admin Mode, select the Enable radio button.

c. Scroll down and select the VLAN ID 200 check box.

d. Enter the following information:

In the Admin Mode field, select Enable.

In the Circuit ID Mode field, select Enable.

In the Remote ID String field, enter rmt_id.

e. Click Apply to save the settings.

Enable DHCP L2 Relay on interfaces 1/0/4,1/0/5, and 1/0/6.

a. Select System > Services > DHCP L2 Relay > DHCP L2 Relay Interface

Configuration. A screen similar to the following displays.

b. Scroll down and select the 1/0/4, 1/0/5, and 1/0/6 check boxes.

c. In the Admin Mode field, select Enable.

d. Click Apply to save the settings.

Enable DHCP L2 relay trust on interface 1/0/6.

Chapter 29. DHCP L2 Relay and L3 Relay

ProSafe Managed Switch