NETGEAR ProSafe GSM5212P Software Administration Manual page 91

ProSafe Managed Switch
a. Select Routing > IP > Advanced > IP Interface Configuration. A screen similar to
the following displays.
b. Under Configuration, scroll down and select the interface 1/0/15 check box. Now
1/0/15 appears in the Interface field at the top.
c. Enter the following information:
• In the IP Address field, enter 192.168.20.2.
• In the Network Mask field, enter 255.255.255.0.
• In the Routing Mode field, select Enable.
d. Click Apply to save the settings.
4. Specify the router ID, and enable OSPF for the switch.
a. Select Routing > OSPF > Basic > OSPF Configuration. A screen similar to the
following displays.
b. Under OSPF Configuration, in the Router ID field, enter 2.2.2.2.
c. Click Apply to save the settings.
5. Enable RIP on port 1/0/11.
a. Select Routing > RIP > Advanced > Interface Configuration. A screen similar to
the following displays.
Chapter 7. OSPF | 91