NETGEAR ProSafe GSM5212P Software Administration Manual page 437

ProSafe Managed Switch
2. Configure 1/0/10 as a routing port and assign an IP address to it.
a. Select Routing > IP > Advanced > IP Interface Configuration. A screen similar to
the following displays.
b. Scroll down and select the interface 1/0/10 check box. Now 1/0/10 appears in the
Interface field at the top.
c. Enter the following information:
• In the IP Address field, enter 192.168.3.2.
• In the Subnet Mask field, enter 255.255.255.0.
• In the Routing Mode field, select Enable.
d. Click Apply to save the settings.
3. Configure 1/0/11 as a routing port and assign an IP address to it.
a. Select Routing > IP > Advanced > IP Interface Configuration. A screen similar to
the following displays.
b. Scroll down and select the Port 1/0/11 check box. Now 1/0/11 appears in the Port
field at the top.
c. Enter the following information:
• In the IP Address field, enter 192.168.5.1.
• In the Subnet Mask field, enter 255.255.255.0.
• In the Routing Mode field, select Enable.
d. Click Apply to save the settings.
4. Enable RIP on interface 1/0/10.
Chapter 28. PIM | 437