NETGEAR ProSafe GSM5212P Software Administration Manual page 74

Managed switch 9.0.2

Hide thumbs Also See for ProSafe GSM5212P:

Table of Contents

c. Click Apply to save the settings.

Enable OSPF on the port 1/0/2.

a. Select Routing > OSPF > Advanced > Interface Configuration. A screen similar to

the following displays.

b. Under Interface Configuration, scroll down and select the interface 1/0/2 check box.

Now 1/0/2 appears in the Interface field at the top.

In the OSPF Area ID field, enter 0.0.0.2.

In the OSPF Admin Mode field, select Enable.

In the Router Priority (0 to 255) field, enter 128.

In the Metric Cost field, enter 32.

c. Click Apply to save the settings.

Enable OSPF on port 1/0/3.

a. Select Routing > OSPF > Advanced > Interface Configuration. A screen similar to

the following displays.

b. Under Interface Configuration, scroll down and select the interface 1/0/3 check box.

Now 1/0/3 appears in the Interface field at the top.

In the OSPF Area ID field, enter 0.0.0.3.

In the OSPF Admin Mode field, select Enable.

Chapter 7. OSPF

ProSafe Managed Switch