Interface Route-Domain Commands; Table 108 Interface Route-Domain Commands - ZyXEL Communications Dimension GS-4024 User Manual

42.11.5 interface route-domain Commands

The following table lists the
Use these commands to configure the IP routing domains.

Table 108 interface route-domain Commands

COMMAND
interface
route-domain
<ip-address>/
<mask-bits>
exit
ip
Chapter 42 Introducing Commands
interface route-domain
dvmrp
igmp <v1|v2>
igmp robustness-
variable <2-255>
igmp query-interval
igmp query-max-
response-time <1-25>
igmp last-member-
query-interval <1-
25>
ospf authentication-
key <k>
ospf authentication-
same-as-area
ospf cost <1-65535>
ospf message-digest-
key <k>
ospf priority <0-
255>
GS-4012F/4024 User's Guide
commands in configuration mode.
DESCRIPTION
Enables a routing domain for
configuration.
Exits from the interface routing-
domain command mode.
Enables this function to permit
VLAN groups beyond the local
switch.
Enables IGMP in this routing
domain.
Sets the igmp robustness variable
on the switch. This variable
specifies how susceptible the
subnet is to lost packets.
Sets the igmp query interval on
the switch. This variable specifies
the amount of time in seconds
between general query messages
sent by the router.
Sets the maximum time that the
router waits for a response to an
general query message.
Sets the amount of time in
seconds that the router waits for a
response to a group specific
query message.
Enables OSPF authentication in
this routing domain.
Sets the same OSPF
authentication settings in the
routing domain as the associated
area.
Sets the OSPF cost in this routing
domain.
Sets the OSPF authentication key
in this routing domain.
Sets the OSPF priority for the
interface. Setting this value to 0
means that this router will not
participate in router elections.
PRIVILEG
E
13
13
13
13
13
13
13
13
13
13
13
13
13
287