Interface Commands; Table 85 Interface Port-Channel Commands - ZyXEL Communications VES-1616F-44 User Manual

VES-1616F/1624F-44 User's Guide
Table 84 Command Summary: Configuration Mode (continued)
COMMAND
vlan1q gvrp
port
port isolation
port isolation
number>
vlan-stacking
<SPTPID>
vlan-type <802.1q|port-based>
wfq

32.11.4 interface Commands

The following table lists the
Use these commands to configure the ports.

Table 85 interface port-channel Commands

COMMAND
interface port-
channel <port-
list>
bandwidth-
limit
bpdu-control
<peer|tunnel|d
iscard|network
>
broadcast-
limit
228
<port
egress set <port-
list>
exit
no egress set
<port-list>
interface port-channel
egress <Mbps>
ingress <Mbps>
DESCRIPTION
Enables GVRP.
Enables port isolation on the
systems.
Enables VLAN port isolation on
all ports.
Enters the VLAN port isolation
mode to configure settings on
the specified port(s).
Enables egress port isolation
on the specified port(s).
Exit from the port isolation
configuration mode.
Disables egress port isolation
on the specified port(s).
Enables VLAN stacking on the
device.
Sets the service provider's TP
(Tagged Protocol) ID.
Specifies the VLAN type.
Sets the switch to use Weight
Fair Queuing (WFQ) queuing.
commands in configuration mode.
DESCRIPTION
Enables a port or a list of ports for
configuration.
Enables bandwidth control on the
port(s).
Sets the maximum bandwidth allowed
for outgoing traffic on the port(s).
Sets the maximum bandwidth allowed
for incoming traffic on the port(s).
Sets how Bridge Protocol Data Units
(BPDUs) are used in STP port states.
Enables broadcast storm control limit
on the switch.
Chapter 32 Introducing the Commands
P
13
13
13
13
13
13
13
13
13
13
13
P
13
13
13
13
13
13