Interface Route-Domain Mode - ZyXEL Communications XS3800-28 Cli Reference Manual

Interface Route-domain
In order to configure layer 3 routing features on the Switch, you must enter the interface routing domain
mode in the CLI.
39.1 Command Summary
The following section lists the commands for this feature.
Table 99 Interface Route Domain Command Summary:
COMMAND
interface route-domain <ip-
address>/<mask-bits>
exit
39.2 Command Examples
Use this command to enable/create the specified routing domain for configuration.
• Enter the configuration mode.
• Enable default routing domain (the 192.168.1.1 subnet) for configuration.
• Begin configuring for this domain.
sysname# config
sysname(config)# interface route-domain 192.168.1.1/24
sysname(config-if)#
DESCRIPTION
Enters the configuration mode for this routing domain.
The mask-bits are defined as the number of bits in the
subnet mask. Enter the subnet mask number preceded
with a "/". To find the bit number, convert the subnet mask
to binary and add all of the 1's together. Take
"255.255.255.0" for example. 255 converts to eight 1's in
binary. There are three 255's, so add three eights together
and you get the bit number (24).
Exits from the interface routing-domain configuration
mode.
Ethernet Switch CLI Reference Guide
142
C
H A P T E R
39
Mode
M P
C 13
C 13