Dvmrp Configuration Error Messages; Figure 91 Dvmrp: Igmp/Rip Not Set Error; Figure 92 Dvmrp: Unable To Disable Igmp Error - ZyXEL Communications Dimension GS-4024 User Manual

Hide thumbs Also See for Dimension GS-4024:
Table of Contents

Advertisement

Table 68 DVMRP
LABEL
Active
Threshold
Index
Network
VID
Active
Apply
Cancel

27.3.1 DVMRP Configuration Error Messages

You must have IGMP/RIP enabled when you enable DVMRP; otherwise you see the screen as
in the next figure.

Figure 91 DVMRP: IGMP/RIP Not Set Error

When you disable IGMP, but DVMRP is still active you also see another warning screen.

Figure 92 DVMRP: Unable to Disable IGMP Error

Each IP routing domain DVMRP configuration must be in a different VLAN group; otherwise
you see the following screen.
Chapter 27 DVMRP
DESCRIPTION
Select Active to enable DVMRP on the switch. You should do this if you want the switch to
act as a multicast router.
Threshold is the maximum time to live (TTL) value. TTL is used to limit the scope of
multicasting. You should reduce this value if you do not wish to flood Layer 3 devices many
hops away with multicast traffic. This applies only to multicast traffic this switch sends out.
Index is the DVMRP configuration for the IP routing domain defined under Network. The
maximum number of DVMRP configurations allowed is the maximum number of IP routing
domains allowed on the switch. See
routing domains.
This is the IP routing domain IP address and subnet mask you set up in IP Setup.
DVMRP cannot be enabled on the same VLAN group across different IP routing domains,
that is, you cannot have duplicate VIDs for different DVMRP configurations (see
on page
186).
Select Active to enable DVMRP on this IP routing domain.
Click Apply to save your changes to the switch's run-time memory. The switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel
to save your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this part of the screen afresh.
GS-4012F/4024 User's Guide
Section 7.6 on page 75
for more information on IP
Figure 93
185

Advertisement

Table of Contents
loading

This manual is also suitable for:

Gs-4012f

Table of Contents