ZyXEL Communications Dimension GS-4024 User Manual page 169

GS-4012F/4024 User's Guide
Figure 80 RIP
The following table describes the labels in this screen.
Table 57 RIP
LABEL
Active
Index
Network
Direction
Version
Apply
Cancel
168
DESCRIPTION
Select this check box to enable RIP on the switch.
This field displays the index number of an IP interface.
This field displays the IP interface configured on the switch.
Refer to the section on IP Setup for more information on configuring IP domains.
Select the RIP direction from the drop-down list box. Choices are Outgoing, Incoming,
Both and None.
Select the RIP version from the drop-down list box. Choices are RIP-1, RIP-2B and RIP-
2M.
Click Apply to save your changes to the switch's run-time memory. The switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel
to save your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring the fields again.
Chapter 24 RIP