Vrrp Configuration; Ip Interface Setup; Figure 107 Vrrp Status; Table 77 Vrrp Status - ZyXEL Communications Dimension GS-4024 User Manual

Figure 107 VRRP Status

The following table describes the labels in this screen.

Table 77 VRRP Status

LABEL
Index
Network
VRID
VR Status
Uplink Status
Poll Interval(s) The text box displays how often (in seconds) this screen refreshes. You may change
Stop

31.3 VRRP Configuration

The following sections describe the different parts of the VRRP Configuration screen.

31.3.1 IP Interface Setup

Before configuring VRRP, first create an IP interface (or routing domain) in the IP Setup
screen (see the
Chapter 31 VRRP
DESCRIPTION
This field displays the index number of a rule.
This field displays the IP address and the subnet mask bits of an IP routing domain
that is associated to a virtual router.
This field displays the ID number of the virtual router.
This field displays the status of the virtual router.
This field is Master indicating that this switch functions as the master router.
This field is Backup indicating that this switch functions as a backup router.
This field displays Init when this switch is initiating the VRRP protocol or when the
Uplink Status field displays Dead.
This field displays the status of the link between this switch and the uplink gateway.
This field is Alive indicating that the link between this switch and the uplink gateway is
up. Otherwise, this field is Dead.
This field displays Probe when this switch is check for the link state.
the refresh interval by typing a new number in the text box and then clicking Set
Interval.
Click Stop to halt system statistic polling.
Section 7.6 on page 75 for more information).
GS-4012F/4024 User's Guide
201