Interface Route-Domain Commands; Table 97 Interface Route-Domain Commands - ZyXEL Communications GS-4012F/4024 User Manual

Table 96 interface port-channel Commands (continued)
COMMAND
vlan-stacking
vlan-trunking
wrr

40.9.5 interface route-domain Commands

The following table lists the
Use these commands to configure the IP routing domains.

Table 97 interface route-domain Commands

COMMAND
interface
route-domain
<ip-address>/
<mask-bits>
exit
ip
Chapter 40 Introducing the Commands
priority <0-7>
role <access |
tunnel>
SPVID <1-4094>
<wt1> <wt2> ...
<wt8>
interface route-domain
dvmrp
igmp <v1|v2>
ospf authentication-
key <k>
ospf authentication-
same-aa
ospf cost <1-65535>
ospf message-digest-
key <k>
GS-4012F/4024 User's Guide
DESCRIPTION
Sets the priority of the specified
port(s) in VLAN stacking.
Sets the VLAN stacking port
roles of the specified port(s).
Sets the service provider VID of
the specified port(s).
Enables VLAN Trunking on
ports connected to other
switches or routers (but not
ports directly connected to end
users) to allow frames
belonging to unknown VLAN
groups to pass through the
switch.
Sets the port(s) to use Weighted
Round Robin queuing (WRR).
Sets the interface to use WRR
queuing. A weight value of one
to eight is given to each variable
wt1
from to
commands in configuration mode.
DESCRIPTION
Enables a routing domain for configuration.
Exits from the interface routing-domain
command mode.
Enables this function to permit VLAN groups
beyond the local switch.
Enables IGMP in this routing domain.
Enables OSPF authentication in this routing
domain.
Sets the same OSPF authentication settings in
the routing domain as the associated area.
Sets the OSPF cost in this routing domain.
Sets the OSPF authentication key in this
routing domain.
wt8
.
264