ZyXEL Communications Dimension GS-4024 User Manual page 132

Table 40 Classifier (continued)
LABEL
Priority
Ethernet
Type
Source
MAC
Address
Port
Destination
MAC
Address
Layer 3
Specify the fields below to configure a layer 3 classifier.
DSCP
IP
Protocol
Source
IP
Address/
Address
Prefix
Socket
Number
Destination
IP
Address/
Address
Prefix
Socket
Number
Add
Chapter 18 Classifier
DESCRIPTION
Select Any to classify traffic from any priority level or select the second option and specify
a priority level in the field provided.
Select an Ethernet type or select Other and enter the Ethernet type number in
hexadecimal value. Refer to
Select Any to apply the rule to all MAC addresses.
To specify a source, select the second choice and type a MAC address in valid MAC
address format (six hexadecimal character pairs).
Type the port number to which the rule should be applied. You may choose one port only
or all ports (Any).
Select Any to apply the rule to all MAC addresses.
To specify a destination, select the second choice and type a MAC address in valid MAC
address format (six hexadecimal character pairs).
Select Any to classify traffic from any DSCP or select the second option and specify a
DSCP (DiffServ Code Point) number between 0 and 63 in the field provided.
Select an IP protocol type or select Other and enter the protocol number in decimal value.
Refer to Table 43 on page 133
You may select Establish Only for TCP protocol type. This means that the switch will pick
out the packets that are sent to establish TCP connections.
Enter a source IP address in dotted decimal notation.
Specify the address prefix by entering the number of ones in the subnet mask.
Note: You must select either UDP or TCP in the IP Protocol field before
you configure the socket numbers.
Select Any to apply the rule to all TCP/UDP protocol port numbers or select the second
option and enter a TCP/UDP protocol port number.
Enter a destination IP address in dotted decimal notation.
Specify the address prefix by entering the number of ones in the subnet mask.
Note: You must select either UDP or TCP in the IP Protocol field before
you configure the socket numbers.
Select Any to apply the rule to all TCP/UDP protocol port numbers or select the second
option and enter a TCP/UDP protocol port number.
Click Add to insert the entry in the summary table below and save your changes to the
switch's run-time memory. The switch loses these changes if it is turned off or loses power,
so use the Save link on the top navigation panel to save your changes to the non-volatile
memory when you are done configuring.
Table 42 on page 132 for information.
for more information.
GS-4012F/4024 User's Guide
131