Setting Port Vid; Enabling Rip; Figure 25 Initial Setup Network Example: Port Vid - ZyXEL Communications Dimension GS-4024 User Manual

GS-4012F/4024 User's Guide
3 Since the VLAN2 network is connected to port 1 on the switch, select Fixed to configure
port 1 to be a permanent member of the VLAN only.
4 To ensure that VLAN-unaware devices (such as computers and hubs) can receive frames
properly, clear the TX Tagging check box to set the switch to remove VLAN tags before
sending.
5 Click Add to save the settings to the run-time memory. Settings in the run-time memory
are lost when the switch's power is turned off.

5.1.4 Setting Port VID

Use PVID to add a tag to incoming untagged frames received on that port so that the frames
are forwarded to the VLAN group that the tag defines.
In the example network, configure 2 as the port VID on port 1 so that any untagged frames
received on that port get sent to VLAN 2.

Figure 25 Initial Setup Network Example: Port VID

1 Click Advanced Applications
and VLAN in the navigation
panel. Then click the VLAN
Port Setting link.
2 Enter 2 in the PVID field for port
1 and click Apply to save your
changes back to the run-time
memory. Settings in the run-time
memory are lost when the
switch's power is turned off.

5.1.5 Enabling RIP

To exchange routing information with other routing devices across different routing domains,
enable RIP (Routing Information Protocol) in the RIP screen.
1 Click IP Application and RIP in the navigation panel.
60 Chapter 5 Initial Setup Example