Configure Ospf Areas; Figure 84 Ospf Configuration: Area Setup; Table 63 Ospf Configuration: Area Setup - ZyXEL Communications Dimension GS-4024 User Manual

25.4 Configure OSPF Areas

To ensure that the switch receives only routing information from a trusted layer 3 devices,
activate authentication. The OSPF supports three authentication methods:
• None – no authentication is used.
• Simple – authenticate link state updates using an 8 printable ASCII character password.
• MD5 – authenticate link state updates using a 16 printable ASCII character password.
To configure an area, set the related fields in the OSPF Configuration screen.

Figure 84 OSPF Configuration: Area Setup

The following table describes the related labels in this screen.

Table 63 OSPF Configuration: Area Setup

LABEL
Name
Area ID
Chapter 25 OSPF
DESCRIPTION
Enter a descriptive name (up to 32 printable ASCII characters) for identification
purposes.
Enter a 32-bit ID (that uses the format of an IP address in dotted decimal notation) that
uniquely identifies an area.
A value of 0.0.0.0 indicates that this is a backbone (also known as Area 0). You can
create only one backbone area on the switch.
GS-4012F/4024 User's Guide
175