Cannot Create, Modify, Or Delete Admin Role; Fc Ids Change After Link Reset; Switch Displays Wrong User - Cisco 9134 - MDS Multilayer Fabric Switch Troubleshooting Manual

Miscellaneous Software Image Issues
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

Cannot Create, Modify, or Delete Admin Role

Symptom
Table 2-12 Cannot Create, Modify, or Delete Admin Role
Symptom
Cannot create, modify, or
delete the admin role.

FC IDs Change after Link Reset

Symptom
Table 2-13 FC IDs Change After a Link Reset
Symptom
FC IDs change after a link
resets.

Switch Displays Wrong User

Symptom
Table 2-14 Switch Displays Wrong User
Symptom
Switch displays the
wrong user with the
show running-config
CLI command.
Cisco MDS 9000 Family Troubleshooting Guide, Release 3.x
2-34
Cannot create, modify, or delete the admin role.
Possible Cause
After upgrading to Cisco SAN-OS Release 2.0,
you cannot create, modify, or delete the admin
role.
FC IDs change after a link resets.
Possible Cause
Following an upgrade from Cisco SAN-OS
Release 1.1 to Cisco SAN-OS Release 1.3 or later,
with persistent FC ID enabled, the FC IDs for the
storage arrays might change after a link flap.
Switch displays the wrong user with the show running-config CLI command.
Possible Cause
When you perform a nondisruptive upgrade from
Cisco SAN-OS Release 1.3(x) to Cisco SAN-OS
Release 2.0(x) and then issue the show
running-config command, the switch displays
the wrong user. The user shown after the
nondisruptive upgrade is different from the user
shown when you issue the show user-account
command.
Chapter 2 Troubleshooting Installs, Upgrades, and Reboots
Solution
Create the admin role before upgrading to
Cisco SAN-OS Release 2.0.
Solution
Reconfigure the FC IDs as necessary.
Solution
Recreate the user.
OL-9285-05