Cisco 9134 - MDS Multilayer Fabric Switch Troubleshooting Manual page 89

Chapter 3 Managing Storage Services Modules
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
The SSM must be running EPLD version 2.1(2) to use the install ssi command. You must install the SSM
Note
on a Cisco MDS 9500 Series switch to update the EPLD. See the
section on page
To upgrade or downgrade the SSM boot image for Intelligent Storage Services, follow these steps:
Log in to the switch through the console port, an SSH session, or a Telnet session.
Step 1
Verify that the SSM is physically installed in the switch. If the module is not physically installed, insert
Step 2
it into the desired slot. Issue a show module command to verify the status of the module.
switch# show module
Mod
---
4
5
6
...
Note the slot number for later reference.
Verify the Cisco MDS SAN-OS release that is running on the switch and verify the location and name
Step 3
of the SSI boot image that is on the switch by following the procedure described in the
SSI Boot Image" section on page
If the SSM boots, then install the SSI image on the SSM.
Step 4
switch# install ssi modflash://4-1/m9000-ek9-ssi-mz.2.1.2.bin module 4
Note
Step 5 If the SSM does not boot, install the SSI image in bootflash on the active supervisor module.
switch# install ssi bootflash:/m9000-ek9-ssi-mz.2.1.2.bin module 4
Note
Install the SSI image on the SSM.
Step 6
switch# install ssi modflash://4-1/m9000-ek9-ssi-mz.2.1.2.bin module 4
Note
Issue the show boot command to display the current contents of the image boot variable for the SSM.
Step 7
switch# show boot
sup-1
OL-9285-05
3-9.
Ports Module-Type
----- -------------------------------- ------------------ ------------
32 Storage Services Module
0 Supervisor/Fabric-1
0 Supervisor/Fabric-1
If the SSM is configured for Layer 3 Fibre Channel switching or Intelligent Storage Services, a
warning displays at the command prompt indicating that the operation will disrupt traffic and
you are then asked if you wish to continue.
If the SSM is configured for Layer 3 Fibre Channel switching or Intelligent Storage Services, a
warning displays at the command prompt indicating that the operation will disrupt traffic and
you are then asked if you wish to continue.
If the SSM is configured for Layer 3 Fibre Channel switching or Intelligent Storage Services, a
warning displays at the command prompt indicating that the operation will disrupt traffic and
you are then asked if you wish to continue.
Model
DS-X9032-SSM
DS-X9530-SF1-K9
DS-X9530-SF1-K9
3-5.
Cisco MDS 9000 Family Troubleshooting Guide, Release 3.x
SSM Issues
"Installing EPLD Images on Modules"
Status
ok
active *
ha-standby
"Verifying the
3-7