Cannot Configure Port In Dedicated Mode - Cisco 9134 - MDS Multilayer Fabric Switch Troubleshooting Manual

Generation 1 and Generation 2 Issues
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Use the show module command to display the reason why a module does not power up.
Step 3
sw# show module
Mod
---
1
2
3
4
5
6
7
8
9
Mod
---
8
* this terminal session
If the module is powered down because of port index issues, use the show module recovery-steps
Step 4
command to determine how to correct the problem.
switch# show module 4 recovery-steps
Failure Reason:
Contiguous and aligned indices unavailable for Generation-1 modules
Check "show port index-allocation" for more details
Please follow the steps below:
1. Power-off module in one of the following slots: 12
2. Power-on module in slot 4 and wait till it comes online
3. Power-on the module powered-off in step 1
4. Do "copy running-config startup-config" to save this setting
Verify that the debug module no-power-down command is not turned on.
Note

Cannot Configure Port in Dedicated Mode

Symptom
Table 5-9 Cannot Configure Port in Dedicated Mode
Symptom Possible Cause
Cannot configure a Not enough bandwidth is available in the
port in dedicated port group.
mode.
Cisco MDS 9000 Family Troubleshooting Guide, Release 3.x
5-10
Ports Module-Type
----- -------------------------------- ------------------ ------------
48 1/2/4 Gbps FC Module
48 1/2/4 Gbps FC Module
48 1/2/4 Gbps FC Module
32 1/2 Gbps FC Module
0 Supervisor/Fabric-1
0 Supervisor/Fabric-1
16 1/2 Gbps FC Module
48 1/2/4 Gbps FC Module
48 1/2/4 Gbps FC Module
Power-Status Power Down Reason
------------ ---------------------------
powered-dn Insufficient resources (dest Index)
Cannot configure port in dedicated mode.
Chapter 5 Troubleshooting Mixed Generation Hardware
Model
DS-X9148
DS-X9148
DS-X9148
DS-X9032
DS-X9530-SF1-K9
DS-X9530-SF1-K9
DS-X9016
DS-X9148
Solution
See the "Verifying Bandwidth Utilization in a Port Group
Using Device Manager" section on page 5-11
"Verifying Bandwidth Utilization in a Port Group Using
the CLI" section on page 5-12.
Status
ok
ok
ok
ok
active *
ha-standby
ok
powered-dn
ok
or the
OL-9285-05