Cisco 9134 - MDS Multilayer Fabric Switch Troubleshooting Manual page 128

Troubleshooting Switching and Services Modules
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Error Message
Explanation
module.
Recommended Action
Error Message MODULE-2-MOD_SOMEPORTS_FAILED: Module [dec] reported failure on ports
[dec]/[dec]-[dec]/[dec] ([chars]) due to [chars] in device [dec] (error [hex]).
Explanation
ports.
Recommended Action
CLI command.
Error Message MODULE-2-MOD_DIAG_FAIL: Module [dec] reported failure on ports
[dec]/[dec]-[dec]/[dec] ([chars]) due to [chars] in device [dec] (device error
[hex]).
Explanation
power cycle the module.
Recommended Action
all module CLI command.
Error Message
has failed loop back tests.
Explanation
Recommended Action
Error Message
snake loopback tests.
Explanation
Recommended Action
Cisco MDS 9000 Family Troubleshooting Guide, Release 3.x
4-32
MODULE-2-MOD_NOT_ALIVE: Module [dec] not responding... resetting.
The module is not replying to the hello message. The module manager will reset the
No action is required.
Module reported a failure in the runtime diagnostic because of a failure in some of the
Collect module information by entering the show module internal all module
The module reported a failure in the runtime diagnostic. Module manager is going to
Collect information about the module by entering the show module internal
SYSTEMHEALTH-2-OHMS_MOD_PORT_LB_TEST_FAILED: Module [dec] Port [dec]
Port loop-back test failure.
No action is required.
SYSTEMHEALTH-2-OHMS_MOD_SNAKE_TEST_FAILED: Module [dec] has failed
Snake test failure.
No action is required.
Chapter 4 Troubleshooting Hardware
OL-9285-05