Recognizing Error States - Cisco 9134 - MDS Multilayer Fabric Switch Troubleshooting Manual

Chapter 2 Troubleshooting Installs, Upgrades, and Reboots
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
INIT: version 2.78 booting
Checking all filesystems..... done.
Loading system software
INIT: Sending processes the TERM signal
Sending all processes the TERM signal... done.
Sending all processes the KILL signal... done.
Entering single-user mode...
INIT: Going single user
INIT: Sending processes the TERM signal
switch(boot)#
The
Step 5 Issue the init-system command to repartition and format the bootflash.
Step 6 Perform the procedure specified in the
Step 7 Perform the procedure specified in the
section on page 2-23
If you do not issue the reload module command when a boot failure has occurred, the active supervisor
Note
module automatically reloads the standby supervisor module within 3 to 6 minutes after the failure.

Recognizing Error States

If you see one or both of the error messages displayed in
specified in the
Figure 2-7
OL-9285-05
prompt indicates that you have a usable Kickstart image.
switch(boot)#
to recover the other supervisor module.
"Recovery Using BIOS Setup for Supervisor-1" section on page
Error State if Powered On and Ctrl-C Is Entered
Troubleshooting Cisco SAN-OS Software System Reboots
"Recovery from the switch(boot)# Prompt" section on page
"Recovering One Supervisor Module With Corrupted Bootflash"
Figure 2-7
Cisco MDS 9000 Family Troubleshooting Guide, Release 3.x
or Figure 2-8, follow the procedure
2-16.
2-21.
2-25