Displaying The Default Values Using The Cli; Setting The Static Route For Fcip Tunnels Using The Cli; Debugging The Configuration Of The Second Switch Using The Cli - Cisco 9134 - MDS Multilayer Fabric Switch Troubleshooting Manual

Chapter 20 Troubleshooting IP Storage Services
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
The FCIP interface will use the local FCIP profile. The FCIP profile binds the FCIP interface to the
physical Gigabit Ethernet port and configures the TCP settings used by the FCIP interface.
MDS1(config-if)# peer-info ipaddr 10.10.11.2
The IP address in this example indicates the remote endpoint IP address of the FCIP tunnel.
MDS1(config-if)# no shutdown
MDS1(config-if)# end

Displaying the Default Values Using the CLI

The following example displays the default values from the show running-config command.
MDS1# show running-config
Building Configuration ...
fcip profile 28
ip address 10.10.10.2
port 3225
tcp keepalive-timeout 60
tcp max-retransmissions 4
tcp pmtu-enable reset-timeout 3600
tcp initial-retransmit-time 100
tcp window-size 64
vsan database
vsan 2 name grumpy_02
interface fcip28
no shutdown
use-profile 28
peer-info ipaddr 10.10.11.2
ip route 10.10.11.0 255.255.255.0 10.10.10.1

Setting the Static Route for FCIP Tunnels Using the CLI

The static route must be set for FCIP tunnels. This route could also be ip route 10.10.11.0 255.255.255.0
interface gigabitethernet 2/8.
ips heartbeat
ips hapreset
ips boot
interface GigabitEthernet2/8
ip address 10.10.10.2 255.255.255.0
(This is the IP address used by the FCIP profile.)
no shutdown

Debugging the Configuration of the Second Switch Using the CLI

The following example shows the configuration of a switch (MDS2) with debug mode activated. To
activate debug mode for this situation, run the debug ips flow fcip command on a separate terminal.
MDS2(config)# fcip profile 28
OL-9285-05
Cisco MDS 9000 Family Troubleshooting Guide, Release 3.x
FCIP Issues
20-11