Recovery For Switches With Dual Supervisor Modules - Cisco 9134 - MDS Multilayer Fabric Switch Troubleshooting Manual

Troubleshooting Cisco SAN-OS Software System Reboots
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Usage for bootflash://sup-local
107465728 bytes used
78619648 bytes free
186085376 bytes total
Load the system image from the bootflash: files system.
Step 9
switch(boot)# load bootflash:system-image1
Uncompressing system image: bootflash:/system-image1
CCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCC
Would you like to enter the initial configuration mode? (yes/no): yes
Note
Log in to the switch using the password configured in
Step 10
switch login:admin
Password:
Cisco Storage Area Networking Operating System (SAN-OS) Software
TAC support: http://www.cisco.com/tac
Copyright (c) 2002-2008, Cisco Systems, Inc. All rights reserved.
The copyrights to certain works contained herein are owned by
other third parties and are used and distributed under license.
Some parts of this software may be covered under the GNU Public
License or the GNU Lesser General Public License. A copy of
each such license is available at
http://www.gnu.org/licenses/gpl.html and
http://www.gnu.org/licenses/lgpl.html
switch#
Step 11 Configure the boot variable.
switch #config t
switch(config)#boot kickstart bootflash:kickstart-image1
switch(config)#boot system bootflash:system-image1
switch(config)#end
switch#
Save the configuration.
Step 12
switch#
[########################################] 100%
switch#

Recovery for Switches with Dual Supervisor Modules

This section describes how to recover when one or both supervisor modules in a dual supervisor switch
have corrupted bootflash.
Cisco MDS 9000 Family Troubleshooting Guide, Release 3.x
2-22
If you enter no, you will return to the
the switch.
copy running-config startup-config
Chapter 2 Troubleshooting Installs, Upgrades, and Reboots
login prompt, and you must manually configure
switch#
Step 9.
OL-9285-05