All Ports Down Because Of System Health Failure; Switch Reboots After Fcip Reload; Fcip Link Fails To Come Up - Cisco 9134 - MDS Multilayer Fabric Switch Troubleshooting Manual

Chapter 2 Troubleshooting Installs, Upgrades, and Reboots
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

All Ports Down Because of System Health Failure

Symptom
Table 2-9 All Ports are Down Because of a System Health Failure.
Symptom
The system console reports
that the module's ports are
down because of a system
health failure.

Switch Reboots after FCIP Reload

Symptom
Table 2-10 Switch Reboot after FCIP Reload
Symptom
Switch rebooted after FCIP
module was reloaded,
upgraded, or downgraded.

FCIP Link Fails to Come Up

Symptom
Table 2-11 FCIP Link Fails to Come Up
Symptom
A newly configured
FCIP link may fail to
come up when running
on an MPS-14/2
module.
OL-9285-05
Console reports all ports on a module are down because of a system health failure.
Possible Cause
An incorrect process on the Cisco MDS
9000 modules might have been
reinitialized from an error recovery
mechanism, leaving the module in an
unusable state. In some cases, the module
may reboot.
Switch rebooted after FCIP module was reloaded, upgraded, or downgraded.
Possible Cause
If an IPS module with operational FCIP
PortChannels is reloaded, upgraded, or
downgraded, the supervisor module might
reload and cause the system to reboot.
A newly configured FCIP link may fail to come up when running on an MPS-14/2 module.
Possible Cause
This symptom may occur following an upgrade
from Cisco MDS SAN-OS Release 2.0(1b) to
Release 2.0(3) and following the configuration of
a new FCIP link.
Miscellaneous Software Image Issues
Solution
Downgrade to a Cisco SAN-OS Release 2.0(x)
version supported by your OSM.
Upgrade to Cisco SAN-OS Release 2.1.2 or
2.1(1b). Resetting the module will clear the
problem, but the problem could reoccur unless
you are using a SAN-OS version with the bug fix.
Solution
Before reloading, upgrading, or
downgrading an IPS module, shut down all
FCIP PortChannels on the module.
Solution
Reload the MPS-14/2 module using the reload
module module-number command, where
module-number is a specific module.
Cisco MDS 9000 Family Troubleshooting Guide, Release 3.x
2-33