Cisco 9134 - MDS Multilayer Fabric Switch Troubleshooting Manual page 285

Chapter 14 Troubleshooting Zones and Zone Sets
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
switch# show zone status vsan 1
VSAN: 1 default-zone: deny distribute: active only Interop: default
Default zone:
Full Zoning Database :
Active Zoning Database :
Status:
The default zone policy of permit means all nodes can see all other nodes. Deny means all nodes are
isolated when not explicitly placed in a zone.
Optionally, use the zone default-zone permit command to set the default zone policy to permit if you
Step 3
are not using zoning. Go to
Use the show zone member command for host and storage device to verify that they are both in the same
Step 4
zone. If they are not in the same zone, see the
Fabric Manager" section on page
Use the show zoneset active command to determine if the zone in
Step 5
in the active zone set.
v_188# show zoneset active vsan 2
zoneset name ZoneSet3 vsan 2
zone name Zone5 vsan 2
If the zone is not in the active zone set, see the
Step 6
Manager" section on page
If there is no active zone set, use the zoneset activate command to activate the zone set.
Step 7
Verify that the host and storage can now communicate.
Step 8
Resolving Host and Storage Not in the Same Zone Using the CLI
To move the host and storage device into the same zone using the CLI, follow these steps:
Use the zone name zonename vsan-id command to create a zone in the VSAN if necessary, and add the
Step 1
host or storage into this zone.
ca-9506(config)# zone name NewZoneName vsan 2
ca-9506(config-zone)# member pwwn 22:35:00:0c:85:e9:d2:c2
ca-9506(config-zone)# member pwwn 10:00:00:00:c9:32:8b:a8
Note
Use the show zone command to verify that host and storage are now in the same zone.
Step 2
switchA# show zone
zone name NewZoneName vsan 2
OL-9285-05
mode: basic merge-control: allow session: none
hard-zoning: enabled
qos: low broadcast: disabled ronly: disabled
Zonesets:0 Zones:0 Aliases: 0
Name: Database Not Available
Step
pwwn 10:00:00:00:77:99:7a:1b [Hostalias]
pwwn 21:21:21:21:21:21:21:21 [Diskalias]
14-6.
switch(config)# zoneset activate ZoneSet1 vsan 2.
The pWWNs for zone members can be obtained from the device or by issuing the show flogi
database vsan-id command.
7.
"Resolving Host and Storage Not in the Same Zone Using
14-6.
"Resolving Zone is Not in Active Zone Set Using Fabric
Cisco MDS 9000 Family Troubleshooting Guide, Release 3.x
Zone and Zone Set Issues
Step 4 and the host and disk appear
14-7