Fcip Interface Misconfiguration Examples; Displaying Fcip Misconfiguration Examples Using The Cli - Cisco 9134 - MDS Multilayer Fabric Switch Troubleshooting Manual

FCIP Issues
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
10.10.11.2:13
(The port is 13 as configured.)
10.10.11.2:13

FCIP Interface Misconfiguration Examples

The examples in this section show FCIP interface misconfigurations.

Displaying FCIP Misconfiguration Examples Using the CLI

The following example shows that the peer-info IP address of the remote endpoint is missing. The debug
output is from the IPS module.
Module-2# debug ips fcip fsm port 1
module-2# Mar 14 21:37:05
Mar 14 21:37:05
Mar 14 21:37:05
Mar 14 21:37:05
Mar 14 21:37:05
Mar 14 21:37:05
(The peer IP address is not set.)
MDS2# show interface fcip 21
fcip21 is down (Link failure or not-connected)
(This line shows the Peer Information as empty. The line should read "Peer Internet address is 10.10.10.2
and port is 3225.")
Cisco MDS 9000 Family Troubleshooting Guide, Release 3.x
20-24
10.10.10.2:65190
0.0.0.0:0
0.0.0.0:3260
port1: 39:FCIP21: SUP-> Port VSAN (1) already set to same value
port1: 40:FCIP21: SUP-> Trunk mode (1) already set to same value
port1: 41:FCIP21: SUP-> Enable tunnel ADMIN UP
port1: 42:FCIP21: Try to Bring UP the Tunnel
port1: 43:FCIP21: Bring up tunnel Failed, peer-ip not set
Hardware is GigabitEthernet
Port WWN is 20:42:00:0b:5f:d5:9f:c0
Admin port mode is auto, trunk mode is on
vsan is 1
Using Profile id 21 (interface GigabitEthernet2/1)
Peer Information
Special Frame is disabled
Maximum number of TCP connections is 2
Time Stamp is disabled
B-port mode disabled
TCP Connection Information
0 Attempts for active connections, 0 close of connections
5 minutes input rate 0 bits/sec, 0 bytes/sec, 0 frames/sec
5 minutes output rate 0 bits/sec, 0 bytes/sec, 0 frames/sec
0 frames input, 0 bytes
0 Class F frames input, 0 bytes
0 Class 2/3 frames input, 0 bytes
0 Error frames
0 frames output, 0 bytes
0 Class F frames output, 0 bytes
0 Class 2/3 frames output, 0 bytes
0 Error frames 0 reass frames
ESTABLISH
LISTEN
0.0.0.0:0
port1: 38:FCIP21: SUP-> Set Port mode 1
Chapter 20 Troubleshooting IP Storage Services
0 0
0 0
LISTEN 0 0
OL-9285-05