Creating The Fcip Interface For The Second Tunnel Using The Cli; Fcip Profile Misconfiguration Examples; Displaying Incorrect Or Nonexistent Ip Address For An Fcip Profile Using The Cli - Cisco 9134 - MDS Multilayer Fabric Switch Troubleshooting Manual

Chapter 20 Troubleshooting IP Storage Services
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

Creating the FCIP Interface for the Second Tunnel Using the CLI

Now the interface FCIP is created for the second tunnel. The same FCIP profile is used for this example.
A separate FCIP profile can be used for each FCIP interface if desired.
MDS1(config-if)#
MDS1(config-if)# interface fcip 23
MDS1(config-if)# use-profile 21
MDS1(config-if)# peer-info ipaddr 10.10.8.2
MDS1(config-if)# no shutdown
MDS1(config-if)# exit
MDS1(config)#
Now the FCIP interface is created for the third tunnel.
MDS1(config)# interface fcip 28
MDS1(config-if)# use-profile 21
MDS1(config-if)# peer-info ipaddr 10.10.7.2
MDS1(config-if)# no shut
MDS1(config-if)# end
MDS1(config)#

FCIP Profile Misconfiguration Examples

The examples in this section show FCIP profile misconfigurations.

Displaying Incorrect or Nonexistent IP Address for an FCIP Profile Using the CLI

MDS22(config)# fcip profile 21
MDS22(config-profile)# ip addr 1.1.1.1
MDS22(config-profile)# ip addr 34.34.34.34
MDS22(config-profile)# exit
MDS22(config)# exit
MDS22# show fcip profile 21
FCIP Profile 21
(In this line, the interface Gigabit Ethernet port is not shown. This means the IP address is not assigned
a Gigabit Ethernet port.
Listen Port is 3225
MDS22# config t
Enter configuration commands, one per line.
MDS22(config)# interface gigabitethernet 2/5
MDS22(config-if)# ip addr 34.34.34.34 255.255.255.0
MDS22(config-if)# no shutdown
MDS22(config-if)# end
MDS22# show fcip profile 34
error: fcip profile not found
MDS22# show fcip profile 21
FCIP Profile 21
(In this line, the Gigabit Ethernet port is now shown and the FCIP profile is bound to a physical port.)
OL-9285-05
Internet Address is 34.34.34.34
TCP parameters
SACK is disabled
PMTU discover is enabled, reset timeout is 3600 sec
Keep alive is 60 sec
Minimum retransmission timeout is 300 ms
Maximum number of re-transmissions is 4
Advertised window size is 64 KB
Internet Address is 34.34.34.34
End with CNTL/Z.
(interface GigabitEthernet2/5)
Cisco MDS 9000 Family Troubleshooting Guide, Release 3.x
FCIP Issues
20-21