Front Usb Panel; Remove The Front Bezel; (Computer Access Panel - Compaq dx1000 - Microtower PC Service & Reference Manual

NOTE: If you are replacing the primary hard drive, use the Recovery Disc Set to restore the operating
system, software drivers, and any software applications that were preinstalled on the computer.

Front USB Panel

1. Prepare the computer for disassembly
2. Remove the computer access panel
3.

Remove the front bezel

4. Disconnect the front USB cable from the yellow system board connector (JAUD1) and the I/O cable
from the white system board connector (FUSB1).
5. Stand the unit upright.
6. Remove the silver T15 screw (1) that secures the panel to the chassis.
7. Slide the panel assembly upward (2), and then pull the assembly away from the unit while threading
the wires through the hole in the front of the chassis.
Figure 6-36
To reinstall the panel, reverse the removal procedure.
60 Chapter 6 Removal and Replacement Procedures Microtower (MT) Chassis
(Front Bezel on page
Removing the front USB panel
(Preparation for Disassembly on page
(Computer Access Panel on page
35).
30).
34).