Switchport Mode - SMC Networks TigerSwitch SMC8612T2 Management Manual

Command Mode
Global Configuration
Example
The following example shows how to set the interface configuration mode
to VLAN 1, and then assign an IP address to the VLAN:
Console(config)#interface vlan 1
Console(config-if)#ip address 192.168.1.254 255.255.255.0
Console(config-if)#
Related Commands
shutdown (4 -174)

switchport mode

This command configures the VLAN membership mode for a port. Use
the no form to restore the default.
Syntax
switchport mode {trunk | hybrid}
no switchport mode
• trunk - Specifies a port as an end-point for a VLAN trunk. A trunk
is a direct link between two switches, so the port transmits tagged
frames that identify the source VLAN. However, note that frames
belonging to the port's default VLAN (i.e., associated with the
PVID) are sent untagged.
• hybrid - Specifies a hybrid VLAN interface. The port may
transmit tagged or untagged frames.
Default Setting
All ports are in hybrid mode with the PVID set to VLAN 1.
Command Mode
Interface Configuration (Ethernet, Port Channel)
VLAN C
OMMANDS
4-235