Connecting Cables - Omron CX-PROCESS TOOL V5.2 - REV 10-2010 Operation Manual

Connecting to the PLC
Connections to the Peripheral
Port of the CPU Unit
CX-Process
Tool
IBM PC/AT or
compatible
(9-pin male)
CS1W-CN226 or
CS1W-CN626
Connecting Cable

1-6-4 Connecting Cables

Unit
CPU Unit Built-in peripheral port
Built-in RS-232C port
F Female 9-pin D-SUB
Serial Communica- RS-232C port
tions Board or Unit i B d U i M l 9 i D SUB Male 9-pin D-SUB
Unit
CPU Unit Built-in peripheral port
Unit
CPU Unit Built-in peripheral port
The connections shown in the following diagram can be used with either Periph-
eral Bus or Host Link connections.
Loop Controller
CS1 CPU Unit
Peripheral
port
The following table lists the Connecting Cables that can be used for Peripheral
Bus and Host Link connections. All of the cables connect to a male 9-pin D-Sub
serial port on an IBM PC/AT or compatible computer.
Port location Serial Commu-
nications Mode
p p p Host Link
(SYSMAC WAY) (SYSMAC WAY)
or Peripheral Bus or Peripheral Bus
p
(Toolbus) (Toolbus)
l 9 i D SUB
p Host Link
(SYSMAC WAY) (SYSMAC WAY)
Note Touch a grounded metal to discharge all static electricity from your body before
connecting any of the above cable connectors to the RS-232C port of the PLC.
The XW2Z-jjjS-CV Cable uses the anti-static XM2S-0911-E Connector
Hood. For safety sake, however, discharge all static electricity from your body
before touching the connector.
The following components are used to connect RS-232C cable to the peripheral
port. Connect to a male 9-pin D-Sub serial port on an IBM PC/AT or compatible
computer.
Port location Serial Commu-
nications Mode
Host Link
(SYSMAC WAY)
or Peripheral Bus
(T lb (Toolbus)
The following components are available for connecting the CQM1-CIF01 or
CQM1-CIF02 Cable to the peripheral port. Connect to a male 9-pin D-Sub serial
port on an IBM PC/AT or compatible computer.
Port on Unit Serial Communica-
tions Mode
Host Link
(SYSMAC WAY)
Connections to the RS-232C port of the CPU
Unit or Serial Communications Board or Unit
CX-Process
Tool
IBM PC/AT or
compatible
(9-pin male)
XW2Z-200S-CV
Connecting Cable
Note The Peripheral Bus connection cannot
be used with a Serial Communications
Board or Unit.
Model
CS1W-CN226
CS1W-CN626
XW2Z-200S-CV
XW2Z-500S-CV
XW2Z-200S-CV
XW2Z-500S-CV
Model
CS1W-CN118 +
XW2Z-200S-CV
p
)
CS1W-CN118 +
XW2Z-200S-V
Model
CS1W-CN114 +
CQM1-CIF02
Section
Loop Controller
CS1 CPU Unit
RS-232C
port
Length Remarks
2.0 m ---
6.0 m
Anti-static connector
2 m
5 m
2 m Anti-static connector
5 m
Length Remarks
0.1 m +
The XW2Z-jjjS-
(2 or 5 m)
CV is an anti-static
connector.
---
Length Remarks
0.5 m + 3.3 m ---
1-6
35