Omron CX-PROCESS TOOL V5.2 - REV 10-2010 Operation Manual page 176

Using SCADA Software
Setting
Tag name (representative tag)
Tag comment
Scaling upper limit
Scaling lower limit
Decimal Point (number of digits
below decimal point for scaling)
Unit
Network address
Node address (See note 1.)
Unit address
Block model
Block address
Block model name
Note a) When the CX-Server is selected, the node address must be set to
a number other than 0 before compiling the SCADA software CSV
tag file.
b) Always set tag names. SCADA software uses these to identify
data.
4. Save the filename, extension, and folder position just as they are.
5. Open the Project again. The editing results will be automatically reflected in
the CSV tag list. The CSV tag list is displayed by selecting Show Tag List/
CSV Tag from the Execution Menu.
6. As required, use the setting method provided under Setting Tags Individual-
ly Using the CSV Settings Dialog Box on page 145 to individually edit the
function block CSV tags.
Step 3: Checking CSV Tags
Check the CSV tag settings by selecting Show Tag List/CSV Tag from the
Execution Menu. The following dialog box will be displayed.
Step 4: Creating SCADA Software or RS View Tag Files (Compiling)
Compile the CSV tag file or the RS View tag file using the following procedure
after setting the CSV tags.
Note When CX-Server has been selected as the communications driver, set the node
address to a non-zero value in the Change PLC Dialog Box before compiling the
CSV tag file. Select Change PLC from the Settings Menu to display the dialog
box. (If the computer is connected online, return the node address setting to 0.)
The following conditions must be met to compile the SCADA or RS View tag file:
1) CSV tags must be set for Control, Operation (except internal switches), and
External Controller Terminal Blocks, and both Send All Blocks (462) and Re-
Setting range
16 characters max. (All characters can be used.)
16 characters max. (All characters can be used.)
–5,000 to 99,999 (e.g., if decimal point is set to 1:
–550.0 to 9,999.9)
–5,000 to 99,999 (e.g., if decimal point is set to 1:
–550.0 to 9,999.9)
0 to 9
8 characters max. (All characters can be used.)
0 to 127
0 to 32
16 to 31, 225
0 to 1,000
0 to 1,000
Input automatically.
Section 3-4
149