Omron CX-PROCESS TOOL V5.2 - REV 10-2010 Operation Manual page 141

Creating Function Block
114
around other blocks, connection lines can be bent at right angles. Connect
the function blocks by clicking at the corner of the bend.
• The ITEM names will be displayed when the cursor is moved to the end-
point ITEM, as shown below.
• Deleting Lines
Right click on a line to delete it. The line will be highlighted in red. Delete
the line from the right-click menu.
• Confirming Connection Line Destinations on Block Diagrams
All information can be displayed for lines connected to ITEMs in block dia-
grams. If an ITEM is left-clicked, all lines connected to the ITEM will be
highlighted in pink.
Note In the Free Location Mode, 64 function blocks can be pasted in one block dia-
gram. Software connections can be made between block diagrams by pasting a
function block with the same block address in each block diagram.
8. The data resulting from the connections will automatically be registered to
the ITEMs for each block. In the above example, the block address and
Section 3-1