Version 2.00 - Omron CX-PROCESS TOOL V5.2 - REV 10-2010 Operation Manual

Version Improvements

1-4-3 Version 2.00

Item
New function blocks
Editing block diagrams
Editing ladder diagrams
Undo
Compiling CSV tags for
SCADA software
Function block data
backup and recovery
ITEM List Monitoring
Find Loop Control Unit
Download, upload, and
compare
The improvements made from version 1.50 to version 2.00 of the CX-Process
Tool are listed in the following table.
Ver. 1.50
Does not support Loop Control
Unit version 2.00
Lines disappear when pasted
function blocks are moved.
Lines must be deleted
individually.
Block connection diagrams
cannot be copied.
Cut, copy, and paste not
supported.
Not supported.
Not supported.
Not supported.
Not supported.
Not supported.
Block diagram information files
(extension: .mtbd) cannot be
uploaded or downloaded.
Ver. 2.00
ES100X Controller Terminal (Block Model 045), 4-point
Warning Indicator (Block Model 110), Arithmetic Operation
(Block Model 126), Time Sequence Data Statistics (Block
Model 153), Receive All Blocks (Block Model 461), and
Send All Blocks (Block Model 462).
ITEMs added for other function blocks. Refer to the Loop
Control Unit Operation Manual for details.
Lines do not disappear when pasted function blocks are
moved.
All the lines connected to specified function blocks or
ITEMs can be deleted at the same time.
Block connection diagrams can be copied and registered
to new Loop Control Unit nodes.
Cutting, copying, and pasting are possible for symbols,
areas, and lines.
The previously executed operation can be undone.
CSV tags can be set for function blocks and CSV tags can
be compiled, saved, and displayed accordingly.
Function blocks in RAM in the Loop Control Unit can be
backed up in flash memory in the Loop Control Unit or the
data in flash memory can be restored to RAM.
ITEM data for a specified function block can be monitored
in a list.
Loop Control Units on networks connected to the PLC to
which the CX-Process Tool is connected can be found and
addresses can be set in node function block files.
Block diagram information files (extension: .mtbd) can be
uploaded or downloaded.
Section 1-4
17