Omron CX-PROCESS TOOL V5.2 - REV 10-2010 Operation Manual page 152

Creating Function Block
Note ITEMs are displayed by default in the order of S and then O. It is pos-
sible to display ITEMs in ascending order by clicking on ITEM. The
following display will appear.
2. Double-clicking on the desired setting item. The corresponding dialog box
will appear.
For example, by double-clicking on the operation cycle of ITEM004, the fol-
lowing dialog box will appear.
3. Input the value and click OK or press the Enter Key. To set the next ITEM,
click Next. To set the previous ITEM, click Back.
Note When the computer is online, you can click Download to download
just the value that was set. If this method is used, the new value will be
downloaded but the ITEM list will not be refreshed and the ITEM list
will show the computer's offline value for that ITEM rather than the
actual value in the Loop Controller.
Section 3-1
125