Omron CX-PROCESS TOOL V5.2 - REV 10-2010 Operation Manual page 66

Basic Operating Procedures
The node is inserted automatically.
38
2. The CX-Process Tool will start and a new project will be created. The Num-
ber-Model setting (e.g., 00-LCB05) will be automatically selected based on
the Loop Control Board/Unit model in the I/O tables.
The Insert LCB/LCU Dialog Box will be displayed.
The Number-Model (e.g., 00-LCB05) is set automatically,
based on the Unit/Board model in the I/O Table Window.
3. Set the System Common Block.
4. Register the function block.
Note (1) For details on setting the System Common Block, refer to 3-1-5 Making Sys-
tem Common Block Initial Settings.
For details on registering function blocks, refer to 3-1-6 Registering
(2)
Function Blocks.
Section 1-7