Displaying Function Block Item Lists; Editing Function Block Items - Omron CX-PROCESS TOOL V5.2 - 12-2009 Operation Manual

Displaying and Setting in Engineering Units

3-9-5 Displaying Function Block ITEM Lists

3-9-6 Editing Function Block ITEMs

1, 2, 3...
Note The enable/disable status for the Engineering Unit Mode is held from the pre-
vious time that the CX-Process Tool was started.
When the Engineering Unit Mode is enabled, converted ITEMs in the ITEM list
are displayed in blue. The values are displayed as engineering units and right-
justified in the Data column in the ITEM list.
(ITEM List Display (Basic PID) with Engineering Unit Mode Disabled)
(ITEM List Display (Basic PID) with Engineering Unit Mode Enabled)
Use the following procedure to input analog data using engineering data.
1. Enter the Engineering Unit Mode as described in 3-9-4 Setting Projects in
Engineering Unit Mode.
2. Open the ITEM Setting Window and click on the General Data input area.
3. The Engineering Input Dialog Box will be displayed. Input the value.
4. If a conversion error occurs, a warning will be displayed. After confirmation,
the rounded value will be set.
Section 3-9
209