Checking Versions - Omron CX-PROCESS TOOL V5.2 - 12-2009 Operation Manual

Monitor Run Status

4-5-4 Checking Versions

1, 2, 3...
Note The unit Ver. of the Loop Controller can be monitored using ITEM 099 as shown
below.
ITEM
099
Indicates that a Loop Controller with Unit Ver. 1.20 is being used.
Check whether the version of the Loop Controller connected online and the ver-
sion of the CX-Process Tool are compatible. Check that the Loop Controller ver-
sion and the version of the created project are compatible.
1. Enable communications with the Loop Controller.
2. Select Check Version from the Execute Menu. The following Check Ver-
sion Dialog Box will be displayed. The following Version Check Dialog Box
will be displayed.
Compatible
The following dialog box will be displayed if the project data currently being
created and the version match.
Incompatible
The following dialog box will be displayed if the project data currently being
created and the version do not match. If they do not match, the project data for-
mat must be converted. Select Change LC Type from the Execution Menu.
Note For the format conversion refer to 3-1-12 Editing Projects.
Data name
MPU/FROM version
Section 4-5
Data
V1.20V1.20
269