Omron CX-PROCESS TOOL V5.2 - 12-2009 Operation Manual page 313

Operation Check
Signal
Outputs Holding (OUT_H)
Not Holding (OUT_L)
Pulse (OUT_P)
Flashing (OUT_F)
Table
STEP (specified step setting
co commands a ds
from other sequence table)
RUN (start from other sequence
table)
STOP (stop from other
sequence table)
ITEM write SET (constant write)
Elements
Timer
Counter
Signal
Outputs p Holding (OUT_H)
Not Holding (OUT_L)
Pulse (OUT_P)
Flashing (OUT_F)
Table
STEP (specified step setting
commands co a ds
from other sequence table)
RUN (start from other sequence
table)
STOP (stop from other
sequence table)
ITEM write SET (constant write)
Elements
Timer
Counter
Present Value Displays
and Set Value Changes
during Operation for
Elements
Output type
g ( _ )
The output status will be as shown in the following table when output signals are
deleted during online editing.
Output type
g ( _ )
g ( _ )
The CX-Process Tool must be version 3.2 or higher, and the LCB05 unit Ver. 1.5
or later, or LCB03 must be used.
Present Values for Elements (Timers and Counters)
The present values of timers and counters will be displayed while validating se-
quence tables. The present values are displayed in parentheses following the
TIM element numbers and CNT elements numbers in the Element column.
Output status before
download
ON
OFF
ON
OFF
ON
OFF
OFF and flashing
ON and flashing
ON and not flashing
Condition already met.
Still timing
Condition already met.
Output status after download
Output will not function.
If previously ON, will turn OFF and then will not function.
If previously OFF, will remain OFF and then will not function.
OFF and then will not function.
If previously flashing
If previously ON and not
flashing
Not executed.
Still timing
Still counting.
Section
Output status after download
OFF until the condition is met
again
OFF
ON
OFF
OFF (opposite status from last
cycle)
ON (opposite status from last
cycle)
ON (opposite status from last
cycle) and flashing
OFF (opposite status from last
cycle) and flashing
ON and not flashing
Not executed.
Timing continues.
Not executed.
OFF and then will not function.
Output will not function.
Timing stops.
The present value of the counter
is held.
4-6
287