Omron CX-PROCESS TOOL V5.2 - 12-2009 Operation Manual page 62

Connecting to the PLC
Controller Link Support
Boards
Connections via Ethernet
Ethernet Unit Model
Using CX-Server
Communications Network type specified
network
Peripheral Bus Select Toolbus.
(Toolbus)
Host Link Select SYSMAC WAY.
(SYSMAC WAY)
34
Controller Link
Support Board
3G8F7-CLK12-V1
3G8F7-CLK13
3G8F7-CLK52-V1
3G8F7-CLK53
3G8F7-CLK21-V1
3G8F7-CLK23
3G8F5-CLK11-V1
3G8F5-CLK21-V1
The personal computer can be connected to the PLC through an Ethernet Net-
work using the FinsGateway ETN_UNIT Driver.
CX-Process Tool
IBM PC/AT or
compatible
Note The FinsGateway ETN_UNIT Driver must be installed in order to connect to the
PLC via an Ethernet Network.
Model
CS1W-ETN01
CS1W-ETN11
CS1W-ETN21
CJ1W-ETN11
CJ1W-ETN21
The following two methods can be used to connect to the PLC.
in dialog box
Special high-speed communications
protocol for Programming Devices
Standard protocol for
general-purpose host computers
Transmission Computer
medium
Optical fiber cable IBM PC/AT or
(ring configuration) compatible
(PCI slot)
(PCI slot)
Wire
IBM PC/AT or
Optical fiber cable
compatible compatible
Wire
(ISA slot)
Loop Control Unit
Ethernet Unit
Ethernet
Ethernet Board
PLC Unit
CS CPU Bus Unit
S i Series
CJ CPU Bus Unit
S i Series
Usage
Section
FinsGateway Driver
CLK (PCI slot) Driver
(FinsGateway Version ( y
2 cannot be used.) 2 t b
Controller Link Driver
Loop Control Unit
Ethernet Unit
Ethernet
10Base-5
10Base-T
100Base-TX
10Base-T
100Base-TX
Cable connection
Connect to the PLC's peripheral
or RS-232C port. o S 3 C po
1-6
d )