Version 5.1; Version 5.2 - Omron CX-PROCESS TOOL V5.2 - 12-2009 Operation Manual

Version Improvements

1-4-11 Version 5.1

Item
Function blocks for gradient
temperature control (Gradient PV
Mode Converter (Block Model 021),
Gradient SP Mode Converter (Block
Model 022), Gradient PID (Block
Model 024), Gradient Precompensator
(Block Model 023))

1-4-12 Version 5.2

Item
Support for LCB01/05
version 3.5 and
CJ1G-CPUjjP
Loop-control CPU Unit
version 3.5
Support for LCB01/05
version 3.6 and
CJ1G-CPUjjP
Loop-control CPU Unit
version 3.6
Engineering unit display
Output window display
Improved sequence for
creating new function block
data
Improved method for adding
function blocks
24
CX-Process Tool version updated from 5.0 to 5.1. The improvements made from
version 5.0 to version 5.1 of the CX-Process Tool are listed in the following table.
Ver. 5.0
Not supported
The improvements made from version 5.1 to version 5.2 of the CX-Process Tool
are listed in the following table.
Previous (Version 5.1)
Support was provided only
up to version 3.0.
---
Analog values could be set
only as percentages.
Data, such as verification
results, was displayed in
fixed dialog boxes.
Only an empty project
workspace was created.
Function blocks could be
added from only from the
menus.
Supported.
10-point control/group for up to 4
groups (when a Loop Controller with
gradient temperature control is used.)
Note: For details on gradient
temperature control, refer to the Loop
Controller with Gradient Temperature
Control Operation Manual (Cat. No.
W460).
Updated (Version 5.2)
The following new blocks are supported:
• Segment Program 3 (Block Model 158)
• Isolated Ai4 Terminal (PH41U, Block Model 572)
• Isolated Ai4 Terminal (AD04U, Block Model 573)
• Ai4 Terminal (ADG41, Block Model 581)
The following new functions are supported:
• Search area number specifications for Segment Program
2 (Block Model 157)
• Easy parameter setting for Segment Program 2 (Block
Model 157) and Segment Program 3 (Block Model 158)
The following function is supported.
• PV lag offset correction function for Segment Program 2
(Block Model 157) and Segment Program 3 (Block Model
158)
An ITEM can be displayed and set in engineering units,
based on scaling information (CSV tag information) for
individual function blocks.
Data, such as verification results, is displayed in special
windows. The following functions are supported.
• Jumping to the relevant location from the displayed results
• Copying results to the clipboard
When a new project is created, all operations from
inserting the Loop Controller to displaying the block
diagram are executed automatically.
Function blocks can be added from a function block
toolbar in the block diagram display.
Section 1-4
Ver. 5.1