Omron CX-PROCESS TOOL V5.2 - 12-2009 Operation Manual page 68

Basic Operating Procedures
Using CX-Process Monitor Plus
40
Note Install the CX-Process Monitor on the same personal computer be-
fore creating monitor tag files.
The procedure depends on whether a Loop Control Unit or Loop Control Board
(LCBjjs) is being used.
Loop Control Units
8.Register and connect the function blocks to exchange data with the CX-Pro-
cess Monitor Plus.
Items to Registrations and
monitor connections
Function Only register the
block data function blocks.
Contact Register and connect
signals the function blocks.
Analog Register and connect
signals the function blocks.
9.Set CSV tags and tags for the CX-Process Monitor Plus as follows:
• Function block data: Set CSV tags.
• Individual contact signals: Set CX-Process Monitor Plus tags for the con-
tacts in the Internal Switch block (Block Model 209).
• Individual analog signals from LCU element to computer: Set CX-Process
Monitor Plus tags for the analog signals in the Input Selection block (Block
Model 162).
• Individual analog signals from computer to LCU element: Set CX-Process
Monitor Plus tags for the analog signals in the Constant Generator block
(Block Model 166).
10.Generate the CX-Process Monitor Plus tag file (Execute – Create Tag File
– Monitor Plus Tag).
11.Start the CX-Process Monitor Plus and click the Start Button.
LCBjjs
8.Register and connect the function blocks to exchange data with the CX-Pro-
cess Monitor Plus.
Items to Registrations and
monitor connections
Function Only register the
block data function blocks.
Contact Register and connect
signals the function blocks.
Analog Register and connect
signals the function blocks.
9.Set CSV tags and tags for the CX-Process Monitor Plus as follows:
• Function block data: Set CSV tags.
• Individual contact signals: Set CX-Process Monitor Plus tags for the con-
tacts in the Internal Switch block (Block Model 209).
• Individual analog signals from LCB element to computer: Set CX-Process
Monitor Plus tags for the analog signals in the Input Selection block (Block
Model 162).
• Individual analog signals from computer to LCB element: Set CX-Process
Monitor Plus tags for the analog signals in the Constant Generator block
(Block Model 166).
10.Generate the CX-Process Monitor Plus tag file (Execute – Create Tag File
– Monitor Plus Tag).
Loop Control Unit
Send All Blocks block (Block Model 462) and
Receive All Blocks block (Block Model 461)
Contact Distributor (Block Model 201) or
Internal Switch (Block Model 209)
Input Selector block (Block Model 162) and
Constant Generator block (Block Model 166)
LCBjjs
HMI settings in the System Common block
(Block Mode 000)
Contact Distributor (Block Model 201) or
Internal Switch (Block Model 209)
Input Selector block (Block Model 162) and
Constant Generator block (Block Model 166)
Section 1-7