Forced Changes To Analog Output Signals - Omron CX-PROCESS TOOL V5.2 - 12-2009 Operation Manual

Operation Check
1, 2, 3...

4-6-5 Forced Changes to Analog Output Signals

276
ITEMs That Can Be Input in Calibration Mode
Block model, ITEM
function block number
001 2-position 007
ON/OFF
002 3-position 007
ON/OFF
011 Basic PID 007
012 Advanced PID 007
013 Blended PID 007
014 Batch Flowrate 007
Capture
031 Indication and 007
Setting
032 Indication and 007
Operation
033 Ratio Setting 007
034 Indicator 007
6. Click the OK or Apply Button.
• If the OK button is clicked, the settings will be reflected and the dialog box
will close.
• If the Apply Button is clicked, the settings will be reflected but the dialog
box will not close.
7. The function blocks on the block diagrams will be displayed as in the follow-
ing figure. (A CAL icon will be displayed in the upper-right corner.) ITEMs set
as input values will be outlined.
Exiting Calibration Mode
Use the following procedure to exit calibration mode.
1. Confirm the operation of block diagrams
2. Right-click a function block for which the Calibration Mode is to be exited.
Right-click and select Wireless Debug from the pop-up window.
3. A dialog box will be displayed. Select the None Option for debugging set-
tings.
4. Click the OK or Apply Button.
From the above Validate Action Screen, analog output signal values can be
changed forcibly after sending the stop block operation command to the function
block. Take the following steps.
Possible ITEM Maximum
setting setting
PV (PV input) 115.00 (%)
PV (PV input) 115.00 (%)
PV (PV input) 115.00 (%)
PV (PV input) 115.00 (%)
P1 (P1 input) 9999
P1 (P1 input) 9999
PV (PV input) 115.00 (%)
PV (PV input) 115.00 (%)
PV (PV input) 115.00 (%)
PV (PV input) 115.00 (%)
Section 4-6
Minimum
setting
–15.00 (%)
–15.00 (%)
–15.00 (%)
–15.00 (%)
0
0
–15.00 (%)
–15.00 (%)
–15.00 (%)
–15.00 (%)