Omron CX-PROCESS TOOL V5.2 - 12-2009 Operation Manual page 140

Creating Function Block
4. Select (i.e., highlight) the block to be pasted in the left pane (the Project
Workspace).
5. Right-click the location at which the block will be pasted in the right pane and
select Paste: Function Block from the pop-up window. The function block
diagram will be pasted as shown in the following figure.
Changing Function Block Positions
Left-click the block. The hand icon (i.e., mouse cursor) will form a gripped hand.
Drag the gripped hand icon to the specified position. The following display will be
shown if another function block already exists at the specified location.
If this display is shown, release the function block after changing the speci-
fied location.
6. The cursor will automatically form a pencil icon when it is moved to the loca-
tion where the connection lines start.
7. Click the ITEM location where the connection lines will start, then point to the
ITEM location where the connection lines will end and double-click. The
connection lines will be displayed. To connect function blocks by going
Section 3-1
113